Feeds:
Posts
Comments

Posts Tagged ‘Mother’s Day Brunch decorations’

The old song goes, “A tisket, a tasket, a green and yellow basket . . .” except in my case the baskets were pearlized baby blue. For Easter dinner I wanted to make something special for each of my guests, so I searched the internet and found a project on AllFreeCrafts.com. I made cute little paper baskets, filled them with my favorite chocolate Cadbury Mini Eggs, and placed one basket at each place setting on the dining table. Because they are easy to make, I thought they could make sweet flower-filled Mother’s Day Brunch favors as well.

Supplies you will need to make these baskets:

*Stiff paper – construction paper or card stock
*Pencil,  embossing tool, or a small point knitting needle
*Ruler
*Scissors
*Hole Punch
*Brad fasteners
*Candy or tiny flowers (in which case you’ll need plastic condiment cups, too)

Instructions:

To make a template, measure and draw a 4-1/2″ square on stiff paper. Divide the square into nine equal squares with your pencil and ruler. Round off each corner with your scissors. Measure and cut out a handle template that is 6″ long by 5/8″ wide. Using your ruler as a straight edge, score the lines that form your nine-square grid. To do this place your ruler on a vertical line and run the embossing tool down the line. Repeat with the remaining vertical line and the two horizontal lines. Now fold the template along these lines.

Place your template on top of your paper and trace around it with a pencil or an embossing tool. I favor the embossing tool because it does not leave any marks that have to be erased later. It only leaves indentations. If you have a fine point knitting needle, this could be used as well. Repeat the procedure for the handle.

Do not remove the template. To score your basket so it can be folded, carefully place your ruler on top of your template and paper (make sure template and paper are lined up according to your tracing) along one of the vertical lines. Fold back the template along the rulers edge, and run the embossing tool down the edge. Repeat procedure on the remaining vertical line and two horizontal lines.

Cut the rounded-square and the handle out. Cut two slits along the center top and center bottom squares.To form one side of a basket, fold two round edges over a center square until they overlap. Punch with a tiny hole punch or fat needle through the three layers. Also punch a hole into each end of the handle making sure your you’ve left at least 1/4″ of paper at the end.

Again fold two round edges over the center square, lining up the holes. Now insert one end of the handle in between the center square and the overlapping rounded ends. Line up the holes and stick a brad in securely. If you do not have mini brads, you could use a staple and then cover the staple with a sticker. Repeat the procedure for the other side of the basket and handle.

Either fill the completed basket with candy or put a disposable plastic condiment cup in the basket. Fill the cup with a little bit of water and arrange some tiny flower stems in it.

Little baskets of flowers would also be very pretty additions to a bridal shower table-scape. Vary the paper or even enlarge the template to make larger baskets. Only your imagination limits you as to how these little baskets can be used!

Read Full Post »

%d bloggers like this: