Feeds:
Posts
Comments

Posts Tagged ‘DIY candle holders’

DIY jar and jute candleholders

Get out those skeins of macrame cord you’ve been saving since the 1970s and pull out those empty glass jars from underneath your kitchen sink. It’s time to upcycle them into retro-chic candle holders! I made these candle holders in just one morning. Their relaxed vibe makes for great centerpieces (outdoor or indoor) or thoughtful gifts. For a morning coffee gathering or a brunch, put a base layer of coffee beans in the jars and let the candles help release the aroma of freshly-roasted coffee!

Materials:
Glass jars (for a more interesting arrangement, choose jars of different heights)
Jute, twine, or macrame cord
Hot glue gun
Assorted lace trim
Bamboo skewers
Tealights
Nonflammable base material such as rice, beans, coffee beans, sand, etc.
Scissors

General Directions:
1. Remove labels from jars. If some adhesive remains, use a solvent such as Goo Gone to remove it.
2. Wash and try jars thoroughly.
3. Heat up your glue gun.
4. Place a little bit of glue on the twine and press it down on the glass jar using a bamboo skewer or your fingers. Using a bamboo skewer prevents burning your fingers on the hot glue. Putting the glue on the twine versus directly on the glass prevents globs of glue from showing up on the glass or getting all over the glass.
5. Because you’re not using a lot of glue, it will set quickly, so work fast. It helps to have a design in mind before you start.
6. Rub off stray glue “threads,” fill jars with base material, and insert tealights.
7. Tie a bow or wrap twine several times around the top of the jar for a more finished look.

Heart Jar:
Laying down a little glue at a time, create a heart-shape perimeter with the twine. Gradually, coil the twine around and around inside the heart-shape, putting down small spots of glue on the back side of the twine as you go. I coiled small circles in between the hearts to balance the design.

Lace Jar:
Starting at the “back” of the jar, I tacked one end of lace to the jar, wrapped it around the jar cutting off the right length, and glued it down on top of where I started. Twine was then centered on the ribbon in between the lace and glued down on the back of the jar. Lace jars in of themselves are pretty, but I felt twine had to be incorporated into the lace design to create a cohesive design grouping.

Loopy Jar:
I started at the bottom of the jar and just looped the jute in a free-form pattern around the jar. When making the loops, it is easier to glue the contact points of a loop before tacking it to the jar.

Love Jar:
This was created in a similar fashion as the loopy jar, except I spelled out the word “love” on the front and back of the jar.

candle holders made from glass jars and jute

Enjoy your candle holders!

Read Full Post »

%d bloggers like this: